2014-2016 : Engineering School - Polytech Grenoble, UGA (bac+5)

Ranking：4/28 (2014 - 2015) & 3/13 (2015 - 2016)

• Filière: Industrial Instrumentation and IT (3I)
• Option: Image-Signal-Automatique (ISA)

2013-2014 : MUNDUS Bridging Program

• Polytech Grenoble,UGA

2009-2013 : Bachelor of Science: Applied Physics

• China University of Petroleum (UPC)

April 2016 - Today: Internship at Temento Systems, Grenoble

• Development of solutions for testing electronic boards.
• Development of automated software test cases using TestComplete

May 2015 - July 2015: Internship at GIPSA-Lab Automatic Department

• Elaboration of a slave CANopen on a STM32F4-Discovery card to communicate with PLC.

June 2014 - July 2014: Internship at laboratory CIME Nanotech, Grenoble

• Development of projects on boards Xilinx Zc706 and ZYBO (Using VHDL). Design of interfaces to connect the board and DAC, ADC and camera.

(Bac+5) Final Year Project: Remote Control of Nacelle for Aerial Photo

• Find a method and develop a way to remote control camera and electronic board.

(Bac+5) Automatic Project : Robust Active Vibration Control

• Identifying an input-output linear model for a system with several weakly damped poles.

• Calculation of a robust controller to reduce the level of noise on the remaining acceleration measured at the output of the system.

(Bac+4) Inter-Sector Project - “Smart Monoski”
(Collaborate with RICM and MATERIAUX)

• Integrating a development board (STM32) in a monoski to get its status using MEMS and Sensors in it.

(Bac+4) Embedded System Project (Arduino)

• Design and make a robot which can follow the line, controlled by Arduino board

(Bac+2) Electronics Project (China University of Petroleum)

• Design and make a high temperature alarm circuit.

(Bac+1) C Programming Project (China University of Petroleum)

• Programming using C to develop a system managing student data.